Before Installing; Parts - Aquacal Pool Pilot Digital Nano Owner's Manual

8.2 BEFORE INSTALLING


Determine everything needed for installation is on hand.

Determine where the Manifold Assembly will be plumbed.

Identify a suitable mounting location for the Digital Nano/Nano + within proper cord length to the
manifold.

Plan runs for cell and Tri-Sensor Cables.

Plan wire runs and wiring connections for source power.

Determine origination point for control center power feed:
o Directly from a circuit breaker (Circuit breaker is used to power the Digital Nano/Nano +
and circulation pump.)
o From an external timer or an electronic controller (Digital Nano/Nano + is to be wired to
the same location as the circulation pump; the Digital Nano/Nano + is activated when the
circulation pump is energized.)
 Determine whether the input voltage for the Digital Nano/Nano + will be 115 Vac or 230 Vac.

8.3 PARTS

Before attempting the installation, verify the following items have been included with the Digital
Nano/Nano + :
Included
QUANTITY
1
1
4
4
QUANTITY
1
1
4
4
Not included
Power service electrical wire.
½" liquid tight (nonmetallic flex) conduit
Digital Nano/Nano + Controllers -115 Vac
Power Cord with 115 Volt Plug – 3 feet
Cell Cable
Plastic Anchors
Mounting Screws
Digital Nano/Nano + Controllers - 220 Vac
6 Foot AC Power Leads
Cell Cable
Plastic Anchors
Mounting Screws
DESCRIPTION
DESCRIPTION
Page 23
Table 4
Table 5
Table 6