Adding Engine Oil; Marine Drive Oil; Mercruiser Bravo Stern Drive Oil Specifications - Yanmar 6LPA-STP2 Operation Manual

BEFORE YOU OPERATE

Adding Engine Oil

1. NOTICE: Prevent dirt and debris
from contaminating engine oil.
Carefully clean the dipstick and the
surrounding area before you
remove the cap. Remove the oil filler
port cap (Figure 6, (4)) from filler port
(Figure 6, (5)) and fill with engine oil.
2. Fill with oil to the upper limit on the
dipstick (Figure 6, (2)). NOTICE:
NEVER overfill the engine with
engine oil.
3. Insert the dipstick fully to check the
level. NOTICE: ALWAYS keep the oil
level between upper and lower lines
on the oil cap / dipstick.
4. Tighten the filler port cap securely by
hand.
1 QuickSilver is a registered trademark of Brunswick Corporation.
32

MARINE DRIVE OIL

Note: Refer to the marine gear
manufacturer's operation manual for the
marine gear oil specifications. Refer to the
manufacturer's operation manual for marine
gear or stern drive oil specifications.
Mercruiser® Bravo Stern Drive
Oil Specifications
Use marine gear oil that meets or exceeds
the following guidelines and classifications:
Drive Oil
• QuickSilver
Lube.
Power Steering Oil (6LPA-STZP2 Only)
• Quicksilver
Fluid or Dexlone-II
Power Trim Oil
• Quicksilver
Fluid or SAE 10W-30 or 10W-40 Engine
Oil
6LPA Series Operation Manual
© 2007 Yanmar Marine International
1
High Performance Gear
®
®
Power Trim and Steering
®
Power Trim and Steering