Checking Engine Oil; Adding Engine Oil - Yanmar 2V Series Operation Manual

Checking Engine Oil

1. Make sure engine is level.
2. Remove oil cap / dipstick (Figure 4, (1)) and
wipe with clean cloth.
(1)
(2)
(3)
Figure 4
3. Fully reinsert oil cap / dipstick but do not
screw in.
4. Remove oil cap / dipstick. The oil level should
be between upper (Figure 4, (2)) and lower
(Figure 4, (3)) lines on the oil cap / dipstick.
5. Fully reinsert oil cap / dipstick (Figure 4, (1))
and hand-tighten. Over-tightening the oil
cap / dipstick will damage it.
2V Operation Manual

Adding Engine Oil

1. Make sure engine is level.
2. Remove oil cap / dipstick (Figure 5, (1)).
0002421
3. Add indicated amount of engine oil at the side
engine oil filler port (Figure 5, (2)).
4. Wait three minutes and check oil level.
5. Add more oil if necessary.
6. Replace oil cap / dipstick (Figure 5, (1)) and
hand-tighten. Over-tightening may damage the
cap.
BEFORE YOU OPERATE
(1)
(2)
Figure 5
0002421B
37