Tripp Lite APSX3024SW Owner's Manual page 6

Apsx pure sine wave dc-to-ac inverter/chargers

Owner's manual (56 pages)

Specification sheet (4 pages)

Datasheet (1 page)

Table of Contents

Available languages

Configuration

To reduce the chance of tripping this breaker, all Inverter/Chargers are pre-set to automatically limit the input current as described in "Most

Limiting" below. If your unit is equipped with DIP switches 7 and 8, they may be used to select other AC input current sharing settings.

Verify that AC input wiring is rated for the higher current that results when using the other settings.

Select Battery Charger-Limiting Points

"Most Limiting" (#7 & #8 Up): Charger-

limiting takes effect the moment any AC load

is applied; charger output falls gradually from

full output at no AC load passing through to

no output at full load (factory setting).

"Less Limiting" (#7 Up & #8 Down):

Charger-limiting begins when the Inverter/

Charger's load reaches 33% of the Inverter/

Charger's load rating. Charger output falls

gradually from full output at 33% of the

Inverter/Charger's load rating to about 33% of full output at full load.

230V Operation (APSX3024SW)

9 10

Select Low VAC Input Voltage Point for Switching

to Battery - OPTIONAL*

Voltage

9, 10 Switch Position

180 VAC

Up, Up

170 VAC

Up, Down

160 VAC

Down, Up

150 VAC

Down, Down (factory setting)

208V Operation (APSX6048VRNET model with Switch #4 in "Up" position)

9 10

Select Low VAC Input Voltage Point for Switching

to Battery - OPTIONAL*

Voltage

9, 10 Switch Position

175 VAC

Up, Up

165 VAC

Up, Down

175 VAC

Down, Up

165 VAC

Down, Down (factory setting)

230V Operation (APSX6048VRNET model with Switch #4 in "Down" position)

9 10

Select Low VAC Input Voltage Point for Switching

to Battery

Voltage

9, 10 Switch Position

180 VAC

Up, Up

170 VAC

Up, Down

180 VAC

Down, Up

170 VAC

Down, Down (factory setting)

* Most of your connected appliances and equipment will perform adequately when your Inverter/Charger's High AC Input Voltage Point and its Low AC

Voltage Input Point is left in the factory setting. However, if the unit frequently switches to battery power due to momentary high/low line voltage swings that

would have little effect on equipment operation, you may wish to adjust these settings. By increasing the High AC Voltage Point and/or decreasing the Low

AC Voltage Point, you will reduce the number of times your unit switches to battery due to voltage swings.

"Least Limiting" (#7 Down & #8 Up):

Charger-limiting begins when the Inverter/

Charger's load reaches 66% of the Inverter/

Charger's load rating. Charger output falls