Identification Of Controls; Front Panel - NAD C 338 Owner's Manual

NA D
1 2 3
1 STANDBY BUTTON
•
Press Standby button to switch ON the C 338 from standby mode.
The Power indicator will change in color depending upon the
status of the C 338.
• Pressing Standby button again switches back C 338 to standby
mode. The Power indicator will change to amber color.
• The Standby button cannot activate the C 338 if the rear panel
POWER switch is off.
• Standby button is also used to clear all Bluetooth (BT) devices. Press
and hold Standby button and all BT devices are cleared.
IMPORTANT NOTES
For the Standby button to activate, the following must occur:
a The supplied power cord from the C 338 must be plugged in to a
power source.
b The rear panel POWER switch must be set to ON.
2 POWER INDICATOR
• This indicator will be amber when the C 338 is in standby mode.
•
When the C 338 is powered up from standby mode, this indicator
will change in color depending upon the status of the C 338.
POWER INDICATOR COLOR CODE
Amber
Short red flash then
double flashing blue
Flashing blue
Solid blue
Solid blue
No light (with flashing "- " display)
Amber (with flashing "- - -" display)
3 HEADPHONE
•
A 1/4" stereo jack socket is supplied for headphone listening and
will work with conventional headphones of any impedance.
•
Use a suitable adapter to connect headphones with other types of
sockets, such as 3.5mm "personal stereo" jack plugs.
4 a SOURCE s
•
Press a SOURCE or SOURCE s to select Sources.
5 DISPLAY
•
Show visual indicators of the Source names, Bass EQ and volume
level.
Hybrid Digital Integrated Amplifier C 338
SOURCE
4 5
DESCRIPTION
Standby mode
Booting
Wi-Fi setup mode (Hotspot mode)
Wi-Fi connection
Firmware upload
Waiting to proceed with firmware
update
Firmware update progress
(update completed when display is
solid "- - - -")

IDENTIFICATION OF CONTROLS

BASS EQ
6 7
6 REMOTE SENSOR
•
Point the AMP 3 remote control at the remote sensor and press the
buttons.
•
Do not expose the remote sensor of the C 338 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the C 338 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30° in each direction of the front of the remote sensor.
7 BASS EQ
• Bass EQ boosts overall bass response by at least 6 dB. "BASS EQ" is
illuminated in the display with BASS EQ enabled.
• Toggle to enable or disable BASS EQ.
8 VOLUME
•
The VOLUME control adjusts the overall loudness of the signal
sent to the speakers and headphone. The Volume control is
characterized by perfect signal tracking and channel balance. It
provides a highly linear and low noise operation.
• Turn clockwise to increase the volume level and counter clockwise
to lower it.
• The default volume level is -20dB.

FRONT PANEL

VOLUME
© NAD C338
8
5