NAD C 338 Quick Start Manual

C 338
Chromecast Built-In
IMPORTANT! Follow these installation steps to add Chromecast casting capability to your C 338 amplifier.
1
Install the Google
Home app on your
mobile device
(If not already installed)
4
Set the POWER switch to ON at
the rear panel of the amplifier
7
Open the Google Home app.
Tap Devices in the top right
corner of the screen
9 Tap Continue once your
mobile device has
successfully connected
to the amplifier in the
Google Home app
CONTINUE
2
Plug in the NAD C 338 and
connect each supplied antenna
to their corresponding
terminals on the rear panel
5
Light
Indicator
Press the front panel standby
button and wait for the power
indicator light to be a steady
pulsing blue
8
Device has
been found
Devices
NADAmplifierDF432A
Needs Setup
IGNORE SETUP
Select the NAD Chromecast
built-in amplifier listed and tap
Set Up Continue
3
Connect a pair of speakers to the
amplifier's corresponding right/left speaker
terminals. Double-check the speakers
before powering on the amplifier
6
Your NAD C 338 is now in
hotspot mode and ready for
Wi-Fi setup
Your mobile device will now
connect to your NAD amplifier
PG 1