IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. 14 Outdoor Antenna Grounding - If an outside antenna or cable system is FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO connected to the product, be sure the antenna or cable system is grounded so EQUIPMENT.
Page 3
(including amplifiers) that produce heat. CAUTION 24 Headphones - Excessive sound pressure form earphones and headphones can Changes or modifications to this equipment not expressly approved by NAD cause hearing loss. Electronics for compliance could void the user’s authority to operate this equipment.
Page 4
Serial no.: ........NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited...
In case you simply cannot wait to experience the performance of your new both sides and behind), and that will provide a clear line of sight, within NAD C 316BEE, we provide the following “QUICK START” instructions to get 23 feet/7 meters, between the C 316BEE’s front panel and your primary you underway.
• With the rear panel POWER switch set to ON position, press this These buttons select the active input to the NAD C 316BEE and the button to turn the C 316BEE ON. The Standby LED indicator will turn signal sent to the loudspeakers or headphones. The AMP 4 remote from amber to blue.
Page 7
IDENTIFICATION OF CONTROLS FRONT PANEL 8 TONE DEFEAT • The TONE DEFEAT switch bypasses the tone control section of the C 316BEE. • If the Tone Controls are not normally used and left in the 12 o’clock position, then it is advisable to switch out the Tone Control section altogether by using this switch.
Page 9
The AMP 4 remote control handset handles the key functions of the C 316BEE. It has additional controls to remotely operate NAD CD Players. It will operate up to a distance of 23ft (7m). When a command from the remote control is received, the Standby LED indicator will blink.
REFERENCE TROUBLESHOOTING CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS No sound. • Power AC lead unplugged or power not • Check if AC lead is plugged in and power switched ON. switched ON. • Mute on. • Switch off Mute. No sound one channel. •...
REFERENCE SPECIFICATIONS All specs are measured according to IHF 202 CEA 490-AR-2008 standard. THD is measured using AP AUX 0025 passive filter and AES 17 active filter. AUDIO SPECIFICATIONS LINE IN/HEADPHONE OUT THD (20 Hz – 20 kHz) <0.03 % in 300 ohms at 2 V out Signal-to-Noise Ratio >100 dB (A-weighted, 32 ohms, ref.
Page 12
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.