Maintenance; Storage - Texas Equipment AE48 Assembly Instructions Manual

Note Behind the lever arm is fitted with a lock pin, which means that the blades cannot be
lowered, while the pin is mounted. This avoids damage if the blades falls down for exam-
ple. during transport.

5. Maintenance

Each time before the product is used, the all bolts and nuts are tightened after.
Lubricate the wheels, if necessary.
If there is rust on the shield or knives, it can be lightly sanded and then painted with enam-
el paint
Always store product in a dry place and apply all the metal parts a little oil when the ma-
chine is not used.
Make sure the blades regularly sharpened.
Never exceed tray load capacity rating of 60 kg. It will damage the plug aerator

6. Storage

• Never allow the extra weight to remain on the aerator for extended periods of time.
• Before storing make sure the aerator is clean and dry for years of trouble free ser-
vice.
• Lightly lubricate all aerator surfaces and moving parts to prevent rust.
• Store indoors or protected area during severe weather and winter months.
As the last to handle aligned and all con-
nections tightened.
Adjust the tray sideways until the lift lever
rests on the right when viewing the ma-
chine from behind.
Tighten the side plates fixed while you
make sure that the handle still rests on the
right.
Tighten the center bracket on the blade
row. Lifting the handle must still rest on the
right and be so tight that it takes effort to
get it out of the right side.
This is to avoid the blades can fall off
h th hi i
www.texas.dk
d
8