Texas Equipment AE48 Assembly Instructions Manual page 15

At the long side of the shaft is mounted as follows in
the correct order. Be aware that bend the bracket
facing the short end of the shaft.
1. Attach an adapter
2. Install a flat washer
3. Attach the center bracket
4. Install a flat washer
5. Attach an adapter
6. Install a set of double knives (blades facing
toward the center.
7. Attach an adapter
8. Attach a set of double knives (blades facing
Turn the wheel suspension, so it ends up.
Attach a side plate, a washer and a sec-
ond suspension. The ring of suspension
should be facing inward. Fix the suspen-
sion to the axis.
Repeat other side.
Put a bolt through the wheel hub and in-
stall a bolt on the other side. Screw it firm-
ly with your fingers. Mount the wheel on
hjulop-soil tare with end bolt of the same
type. Do the same on the vehicle other.
Note the wheels must be able to run easily
round.
Install the outboard bracket on the shaft
www.texas.dk
6