Table of Contents
Advertisement
Salt......
Salt
The hardness of water varies from place to place. If hard water is
used in the appliance, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt
specifically designed to eliminate lime and minerals from the water.
Loading the Salt into the salt container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should
be filled as follows:
- Remove the lower rack and then unscrew and remove the cap
from the salt container;
- If you are filling the container for the first time, fill it with water.
- Place the end of the funnel (supplied) into the hole and intro-
duce about 2 kg of salt. It is normal for a small amount of water
to come out of the salt container.
- Carefully screw the cap back on.
The salt container must be filled when the "low salt" indicator
light (located on the control panel), comes on.
To prevent the formation of rust, load the salt just be-
fore beginning a wash cycle.
GB
Adjusting salt consumption
You can adjust the amount of salt used to suit the hardness of
the water in your area. This is intended to optimize the level of
salt consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
- Unscrew the cap from the salt container;
- There is a ring on the container with an arrow on it (see figure
to the side),
- If necessary, rotate the ring in an anticlockwise direction from
the "-" setting towards the "+" sign, based on the hardness of
the water being used.
It is recommended that adjustments be made in accordance
with the following:
Water Hardness
Clarke
º
dH
Level
mmol/l
degrees
0-1 7
0-1 , 7
1
0-14
1 4-36
1 8-44
1 , 8-4, 4
2
36-71
45-89
4, 5-8, 9
3
>71
>89
4
.3.
Salt
Selector
c o n s u m p t i o n
position
(Grams/cycle)
/
0
" -"
20
middle
40
>8, 9
" +"
60
Autonomy
(cycles/2kg)
/
60
40
25
Advertisement
Table of Contents
