Winco 5900 User Instructions

Comfort Care, Elite Recliner
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.
If you have trouble understanding these instructions contact your dealer or Winco customer support, (800) 237-3377
Winco assumes no responsibility for damage or injury caused by the improper assembly, installation or
use of these products; or during assembly or maintenance of these products.
1. READ AND FOLLOW ALL DIRECTIONS.
2. NEVER use side table as a seat.
3. DO NOT put hands, feet or clothing into any openings when changing positions on recliner. Attendant
MUST confirm that users hands and feet are safe while changing recliner positions or SERIOUS
INJURY MAY RESULT.
4. Stay clear of the recline mechanisms.
5. Remove or move chair accessories out of the way of patients legs (ie. over-lap table & pivot table) when
reclining/changing position of patient.
6. Periodically, recheck tightness of all nuts, bolts and screws.
7. Never use the chair arms or backrest as a seat; SERIOUS INJURY MAY OCCUR.
8. LOCK casters at all times when chair is stationary. UNLOCK casters when moving/transporting chair.
9. Chair must ALWAYS be positioned on a level surface.
10. DO NOT use recliner for Transporting in or with ANY type of vehicle or trailer. Winco recliners have not
been tested or approved for use by an occupant in any type of vehicle or trailer.
11. Immediately remove from service; Any recliner with broken recline mechanisms, torn upholstery, or other
mechanical or visible damage.
12. USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.
13. NEVER EXCEED the recommended weight capacity of 275 lbs. (124.7 kg).
14. SAVE THESE INSTRUCTIONS for future reference and training.
DO NOT LIFT OR CHANGE CHAIR POSITION BY USING THE LEGREST.
THIS COULD CAUSE INJURY TO USER OR DAMAGE TO THE RECLINE MECHANISM AND WILL VOID WARRANTY.

Assembly Instructions - NO TOOLS REQUIRED

PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY
Install the Back:
1. After checking your product for any shipping damage, chair needs to be positioned upright on level surface.
Remove all packing material and hardware that was secured for shipping. Remove tape and plastic. If using
scissors or knife, please be careful not to damage upholstery.
2. Make sure footrest is in closed postion & LOCK ALL CASTERS before installing chair back.
006275
5900
before attempting to use this product; otherwise injury may occur.
TO REDUCE THE RISK OF INJURY TO PERSONS:
ALWAYS CHANGE POSITION FROM BACK OF CHAIR.
5900 Weight Capacity = 275 lbs. (124.7 kg)
Rev N Date 02-14-17
CUSTOMER INSTRUCTIONS
Page 1 of 8
SLC