For Safe Operation - JUKI MH-380 Instruction Manual

140331
1. Keep your hands away from needle when you turn ON the power switch or while the machine
2. Do not put your fingers into the thread take-up cover while the machine is operating.
3. Turn OFF the power switch when tilting the machine head, or removing the belt cover or the V
4. During operation, be careful not to allow your or any other person's head, hands or clothes to
5. Do not operate your machine with the belt cover and finger guard removed.
6. When tilting the machine head, be sure to confirm that the head support bar is properly
1. To ensure safety, never operate the machine with the ground wire for the power supply
2. When inserting/removing the power plug, the power switch has to be turned OFF in advance.
3. In time of thunder and lightening, stop your work and disconnect the power plug from the
4. If the machine is suddenly moved from a cold place to a warm place, dew condensation may be
5. To prevent fires, periodically draw out the power plug from the plug socket and clean the root
6. The loopers oscillate at a high speed during operation.
7. To avoid possible accidents due to abrupt start of the machine, be sure to turn OFF the power
8. Be careful of handling this product so as not to pour water or oil, shock by dropping, and the
9. When tilting or returning the sewing machine to the home position, hold the upper side of the
CAUTION :
Note that safety devices such as "belt cover", "finger guard", etc. may be omitted from the
illustrations in this Instruction Manual for easy explanation.
When operating the machine, be sure not to remove these safety devices.
is in operation.
belts.
come close to the handwheel, V belt and motor. Also, do not place anything close to them.
attached to your machine head, and be careful not to allow your fingers or the like to be
pinched in the machine head.
removed.
receptacle so as to ensure safety.
observed. In this case, turn ON the power to the machine after you have confirmed that there is
no danger of water drops in the machine.
of the pins and the space between pins.
Be sure to keep your hands away from the vicinity of the loopers to protect hands from
possible injury during operation. Turn the power OFF before threading the machine head.
to the machine.
like since this product is a precision instrument.
machine head with both hands and perform the work quietly so that fingers or the like are not
caught in the machine.

FOR SAFE OPERATION

x