Assembly / Pre-Operation; To Assemble The Grass Catcher - Yardworks 060-1662-4 Instruction Manual

Table of Contents

Advertisement

model numbers 060-1662-4 | 060-1663-2 | 060-1664-0 | 060-1665-8 | contact us: 1.866.523.5218
ASSEMBLY/PRE-OPERATION
CAUTION: Read complete INSTRUCTION
MANUAL before operating this machine.
IMPORTANT: THIS LAWN MOWER IS SHIPPED
WITHOUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory
with the exception of those parts left unassembled for
shipping purposes. All parts such as nuts, washers,
bolts, etc., necessary to complete the assembly have
been placed in the parts bag. To ensure safe and proper
operation of your lawn mower, all parts and hardware you
assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
SETUP
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel
3. Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle.
4. Roll lawn mower out of carton and check carton
thoroughly for additional loose parts.
HOW TO SET UP YOUR LAWN MOWER
IMPORTANT: Unfold handle carefully to avoid pinching
or damaging the control cables.
1. Raise handles until lower
handle section locks into
place in mowing position.
2. Insert handle bolts into
lower handle. Install and
tighten knobs to secure
the handle.
2
3. Remove protective
padding, raise upper
handle section into
place on lower handle.
4. Tighten knobs to
secure the handle.
5. Remove handle padding holding operator presence
control bar to upper handle (IF EQUIPPED).
NOTE: For some models, the lawn mower handle can
6. Loosen knob on upper
handle.
7. Slowly pull engine starter
handle.
8. Slip starter rope into loop
on upper handle.
NOTE: Make sure loop is
facing UP.
9. Tighten knob.
TO ASSEMBLE THE
GRASS CATCHER
1. Put the grass catcher
frame into the grass bag
with the rigid part of the
bag on the bottom. Make
sure the frame handle is
outside of the bag top.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

060-1664-0060-1663-2060-1665-8

Table of Contents