Assembly / Pre-Operation; How To Set Up Your Lawn Mower; To Assemble The Grass Catcher - Yardworks 060-1330-4 Instruction Manual

ASSEMBLY/ PRE-OPERATION
CAUTION: Read complete INSTRUCTION
MANUAL before operating this machine.
IMPORTANT: THIS LAWN MOWER IS SHIPPED
WITHOUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at
the factory with the exception of those parts left
disassembled for shipping purposes. All parts such
as nuts, washers, bolts, etc., necessary to complete
the assembly have been placed in the parts bag.
To ensure safe and proper operation of your lawn
mower, all parts and hardware you assemble must
be tightened securely. Use the correct tools as
necessary to ensure proper tightness.
SETUP
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end
panel down flat.
3. Remove all packing materials except padding
between upper and lower handle and padding
holding operator presence control bar to upper
handle.
4. Roll lawn mower out of carton and check carton
thoroughly for additional loose parts.

HOW TO SET UP YOUR LAWN MOWER

IMPORTANT: Unfold handle carefully to avoid
pinching or damaging the control cables.
1. Insert the lower
handle to the two
side brackets on the
mower deck. Use
corresponding holes
on the brackets
when attaching lower
handle pin for a
suitable handle height
desired.
NOTE: The washer
should be pressed
against the inner face of
the bracket.
2. Fasten the lower
handle to the lawn
mower by using
fixing knob
raise
lower
handle bolts,
install and tighten
knobs to secure
the handle.
Raise the upper handle
into place and attach it
to lower handle by using
handle bolts.
4. Install and tighten knobs to secure the handle.
NOTE: Your lawn mower handle can be adjusted
for your mowing comfort. Refer to the "TO ADJUST
HANDLE" section of the operator's manual.
5. Slip starter rope
into loop on upper
handle.
6. Attach the
connection cord
to the handle
with the cord clip
(supplied).

TO ASSEMBLE THE GRASS CATCHER

1. Put the grass
catcher frame into
the grass bag with
the rigid part of the
bag on the bottom.
Make sure the
frame handle is
outside of the bag
top.
2. Slip the vinyl
bindings over the
frame.
bolt
fixing knob
1
2
2
2
2
9
®
/MD