Installing The Fan - NEC LS2400 Service & Reference Manual

Installing the Fan

1. Power off the system and remove the left side panel as described
earlier in this chapter.
2. Remove the hard disk drive bay as described earlier in this chapter.
3. Position the fan as shown against the inside of the rear panel. The
fan label faces the rear panel and the fan power cable is positioned
at the bottom right side of the fan.
4. Install the four screws that secure the fan to the chassis rear panel.
5. Connect the fan cable to the system board.
6. Install the hard disk drive bay as described earlier in this chapter.
7. Install the side panel as described earlier in this chapter.
8. Power on the system.
Installing the Fan
Fan Connector
Pri.
Sec.
Upgrading Your System 4-41