Admin Setup - Oki C612 User Manual

A
DMIN SETUP
ITEM
Enter
Password
Network Enabling Default
Setup Gateway
Wired
TCP/IP
NetBIOS over TCP
IP Address Set
IPv4 Address
Subnet Mask
Gateway Address
DHCPv6
Web
Telnet
FTP
IPSec (if enabled)
SNMP
SETTINGS EXPLANATION
xxxxxxxxxxxx Enter a password to gain entry to the Admin
Setup menu.
Password should be from 6 to 12 digits of
alpha/numeric characters (or mix)
The default value is "999999"
Wired Sets a valid default gateway.
Wireless Display Conditions:
(Infrastructure)
There should be built-in wireless LAN support
and Boot Menu > Wireless Module should
be enabled.
Enable Enables/Disables the wired LAN.
Disable
Enable Sets TCP/IP Protocol.
Disable Enable: TCP/IP Protocol is available.
Disable: TCP/IP Protocol is not available.
Enable Sets Enable/Disable of NetBIOS over TCP
protocol.
Disable
Display Conditions: TCP/IP should be enabled.
Auto Sets the IP Address setting method.
Manual Display Conditions: TCP/IP should be enabled.
xxx.xxx.xxx.xxx Sets the IP Address.
Display Conditions: TCP/IP should be enabled.
xxx.xxx.xxx.xxx Sets the Subnet Mask.
Display Conditions: TCP/IP should be enabled.
xxx.xxx.xxx.xxx Sets the Gateway (default router) address.
0.0.0.0 means that there is no router.
Display Conditions: TCP/IP should be enabled.
Enable Sets Enable/Disable of DHCPv6.
Disable
Enable Sets Enable/Disable of Web.
Disable Enable: Web/IPP is available.
Disable: Web/IPP is not available.
Display Conditions: TCP/IP should be enabled.
Enable Sets Enable/Disable of Telnet.
Disable Enable: Telnet is available.
Disable: Telnet is not available.
Display Conditions: TCP/IP should be enabled.
Enable Sets Enable/Disable of FTP.
Disable Enable: FTP is available.
Disable: FTP is not available.
Display Conditions: TCP/IP should be enabled.
Enable Sets Enable/Disable of IPSec. Enable via the web.
Disable Enable: IPSec is available.
Disable: IPSec is not available.
Enable Sets Enable/Disable of SNMP.
Disable Enable: SNMP is available.
Disable: SNMP is not available.
Display Conditions: TCP/IP or NetWare
should be enabled.
Menu functions > 33