Admin Setup - Oki C711cdtn User Manual

A
DMIN SETUP
ITEM
Enter
Password
Network TCP/IP
Setup
IP Version
NetBEUI
NetBIOS
over TCP
NetWare
EtherTalk
Frame Type
IP Address
Set
IPv4
Address
Subnet Mask
SETTINGS EXPLANATION
xxxxxxxxxxxx Enter a password to gain entry to the Admin Setup menu.
Password should be from 6 to 12 digits of alpha/numeric
characters (or mix)
The default value is "aaaaaa"
Enable Sets TCP/IP Protocol.
Disable Enable: TCP/IP Protocol is available.
Disable: TCP/IP Protocol is not available.
IP v4 Set up the IP version.
IP v4+v6 Operates with IPv4 for IPv4 (not valid with IPv6).
IP v6 Operates with both IPv4 and IPv6 for IPv4+v6.
Operates with IPv6 for IPv6 (not valid with IPv4).
There is only IPv4 and IPv4+v6 as normal value.
From this stage, if IPv6 only is set from UI, for example
Telnet, "IPv6" appears as the value of IP Version on the
operation panel. "IPv6" will disappear from the value if "IP
v4" or "IP v4+v6" is selected.
Display Condition: TCP/IP should be enabled.
Enable Sets Enable/Disable of NETBEUI Protocol.
Disable
Enable Sets Enable/Disable of NetBIOS over TCP protocol.
Disable Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
Enable Sets Enable/Disable of NetWare Protocol.
Disable
Enable Sets Enable/Disable of EtherTalk Protocol.
Disable
Auto Sets the frame type.
802.2 Display Condition: Netware should be enabled.
802.3
Ethernet II
SNAP
Auto Sets the IP Address setting method.
Manual Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
xxx.xxx.xxx.xxx Sets the IP Address.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
xxx.xxx.xxx.xxx Sets the Subnet Mask.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
Menu functions > 30