Table of Contents
Advertisement
56-21XX and 56-22XX Series
DOPSM2097X012
equipment supplier for evaluation and prompt service . Equipment is restored to the original
factory performance specifications, if repairable. There are flat fee repair charges for each
standard model . The original equipment warranty applies after a complete overhaul .
Proper Component Selection
1 . Consider the total system design when selecting a component for use in a system .
2 . The user is responsible for assuring all safety and warning requirements of the application
are met through his/her own analysis and testing .
3 . TESCOM may suggest material for use with specific media upon request. Suggestions
are based on technical compatibility resources through associations and manufacturers .
TESCOM does NOT guarantee materials to be compatible with specific media -- THIS IS
THE RESPONSIBILITY OF THE USER!
4 . Due to the varying composition, viscosity, corrosiveness and density of chemical fluids,
the fluid media and full system must be considered by the user when selecting a product.
This is required to ensure regulator performance, user safety, flow capability and system
level performance .
5 . Component function, adequate ratings, proper installation, operation and maintenance
are the responsibilities of the system user .
Do not modify equipment or add attachments not approved by the manufacturer. Failure to
do so can result in death, serious injury and/or property damage.
ASSEMBLY/INSTALLATION DRAWINGS AND BILLS OF MATERIAL drawings and parts lists for your
product may be obtained by contacting TESCOM. TESCOM will provide these by email, fax or
mail. Your local TESCOM representative can provide additional assistance. Be sure to have your
complete model number ready.
Section 3: Introduction
TESCOM 56-21XX and 56-22XX Series Chemical injection flow control devices are
specifically designed for offshore chemical injection applications. The 56-21XX and
56-22XX Series utilize metering valves which allow for precise control of large flow ranges
at pressures up to 15,000 psig / 1034 bar.
Section 3: Introduction
October 2016
7
Advertisement
Table of Contents
