Table of Contents
Advertisement
Feiyu Electronics Company
Gyroscope initialization (re-setting):
Out of the box, the FY31AP has been fully initialized. However, if the following conditions
occur, resetting the gyro is recommended:
1.
The device has not been used for a long time.
2. There is a change in environmental temperature of over 30 degrees.
3. When the red LED light flashes even when the aircraft is stationary.
Initialization / Reset Procedure
Install the jumper as shown above:
Power-ON the FY31AP and keep it stationary for at least 20 seconds. You will notice the
red light blink at two different rates (or turns off). Gyro re-setting is complete.
Disconnect power, unplug the jumper and keep it in a safe place for future use).
NOTE:
Carry out this re-setting procedure only if the 3 conditions (above) occur. The
unit does not need to be horizontal during initialization. However, you must ensure there
is no vibration during this process. If you suspect shaking had occurred, restart the reset
process.
30 |
P a g e
8
7 6
[END OF MANUAL]
Note: This manual may be updated from time to time.
5
4
3
2
1
A
B
C
Advertisement
Table of Contents
