Advertisement
PRE-FILTER
•
The Pre-filter is located on the HEPA filter casing. This can be removed from the
casing for cleaning.
•
The Pre-filter is responsible for stopping large particles of dirt and debris from
reaching the HEPA filter.
•
If the filter is covered in dust, tap it gently over some newspaper or on the rim of a
rubbish bin to dislodge the dust.
•
If it's very dirty, soak it in warm soapy water for a few minutes, rinse under a
running tap, remove all traces of soap, then let it air dry – do NOT refit until it is
completely dry.
HEPA FILTER
•
The HEPA filter is responsible for cleaning the return air and requires careful handling.
•
If the filter is covered in dust, tap it gently over some newspaper or on the rim of a
rubbish bin to dislodge the dust.
•
If it is very dirty, soak it in warm soapy water for a few minutes, rinse under a
running tap, remove all traces of soap, then let it air dry – do NOT refit until it is
completely dry.
•
Refit the pre-filter into the HEPA filter casing and then refit the HEPA filter assembly
by locating the lugs into the corresponding holes in the dust bin and pushing the
top latch into place.
AIR OUTLET FILTER
•
The air outlet filter is located on the back of the vacuum cleaner.
•
Push the release button sideways to release the grille. Remove the air outlet filter grille
by pulling away from the appliance. Once the grille is off, the filter is easily accessible.
•
If the filter is covered in dust, tap it gently over some newspaper or on the rim of a
rubbish bin to dislodge the dust.
•
If it is very dirty, soak it in warm soapy water for a few minutes, rinse under a
running tap, remove all traces of soap, then let it air dry – do NOT refit until it is
completely dry.
•
Fit the air outlet filter into the rear of the grille. Refit the grille by locating the lugs
into the corresponding holes and push the latch into place.
CLEANING THE VACUUM CLEANER
•
Before cleaning, switch the power off and remove the plug from the wall power outlet.
•
Do not put any part of the cleaner in a dishwasher.
•
Do not use harsh or abrasive cleaning agents or solvents.
•
Wipe external surfaces with a damp cloth. A dab of washing-up liquid will remove
stubborn stains.
•
Wipe the tools with a damp cloth or hand wash in warm soapy water. Rinse under a
running tap to remove all traces of soap, then let air dry – do NOT refit until they are
completely dry.
•
Wipe the extendable tube and hose with a damp cloth. Check they are dry
before refitting. Do not put them in water, you will damage them.
RHF206P_IB_FA_091012.indd 8
12/10/12 11:29 AM
Advertisement
