Important Safeguards Read the instructions before use and keep them safe. Pass them on if you pass the cleaner on. When using electrical appliances, basic safety precautions should always be followed, including the following: 1. The cleaner must only be used by or under the supervision of a responsible adult.
Page 3
8. If using the cleaner outdoors (e.g. cleaning the car), connect it to the electricity supply through a residual current device (RCD) with a rated residual operating current not exceeding 30mA. 9. Do not leave the cleaner unattended when plugged in. 10.
Before using for the first time Carefully remove all contents from the box. As some parts may be packed separately, check all of the packing before disposal. brush pedal flexible hose extend retract suction locks control hose end combination floor tool nozzle small crevice...
Fitting the hose 1. Push the hose end into the inlet. You’ll hear a click as it locks into position. 2. Give it a gentle tug to check it’s fitted properly. Power Cord 3. Pull as much cable as you need from the back of the cleaner. 4. A yellow band around the cable will appear when there is approximately one metre of cable left.
14. The crevice tool can be used with or without the extender tube and can be used on upholstery, in awkward spaces and nooks to remove pet hair, lint and dust from blinds, curtains and upholstery; a. The small brush is part of the crevice tool. To store it, turn it back, parallel to the crevice tool.
Page 7
Finished cleaning? 26. Press and release the power on/off button to turn the cleaner off. 27. Turn of the power socket (if it’s switchable) and unplug the cleaner. 28. Stand clear of the cable, press and hold the cable rewind button. 29. Keep clear of the cable, it rewinds quite quickly and can flick up or catch on corners and furniture.
Cleaning the vacuum cleaner 44. Switch the cleaner off and unplug it before cleaning. 45. Don’t put any part of the cleaner in a dishwasher. 46. Don’t use harsh or abrasive cleaning agents or solvents. 47. Wipe external surfaces with a damp cloth. A dab of washing-up liquid will remove stubborn stains.
Page 9
59. If the filter is covered in dust, tap it gently over some newspaper or on the rim of a rubbish bin to dislodge the dust. 60. If it’s very dirty, soak it in warm soapy water for a few minutes, rinse under a running tap, remove all traces of soap, then let it air dry – do NOT refit until it’s completely dry.
Page 10
74. If it’s very dirty, soak it in warm soapy water for a few minutes, rinse under a running tap, remove all traces of soap, then let it air dry – do NOT refit until it’s completely dry. 75. When it’s dry, replace it in the rear of the cleaner. 76. The soft foam side of the filter should be towards the cleaner and the firm white side of the filter should be towards the cover.
Ease of operation In store demo Prior experience with Salton Product features Seen in store Special offer Prior experience with Russell Hobbs Salton reputation Seen on television Recommendation of family/friend Russell Hobbs reputation Seen in newspaper/magazine (email address must be supplied)
Page 12
AUSTRALIAN CUSTOMER SERVICE NEW ZEALAND CUSTOMER SERVICE Salton (Aust) Pty. Ltd. Salton NZ Ltd. P.O. Box 683 P.O. Box 300 201 Braeside Victoria 3195 Albany Auckland 0752 Australia New Zealand Freecall: 1800 427 842 Freecall: 0508 629 777 Hours: 9am-5pm (EST) Mon-Fri Hours: 9am-5pm Mon-Fri www.salton.com.au www.salton.co.nz...
Need help?
Do you have a question about the RHF208 and is the answer not in the manual?
Questions and answers