Table of Contents
Advertisement
3 M
OUNTING
3.1 M
OUNTING OPTIONS
The device is intended for installation on control panels. If the device is mounted
somewhere else, then the required ambient conditions should always be provided.
Caution:
Preventing overheating during operation: The device should not be exposed to direct
sunlight or other sources of light.
Measures to prevent heat accumulation should be implemented if the device is installed in
a console, casing or similar enclosing structure. The maximum permissible ambient
temperature should not be exceeded.
The front is only IP65 protected if mounted correctly.
Pos : 14 /D atentec hni k/Montage/Montages kiz zen/Auß enabmess ungen des Ger äts/M ontages kizz e des Ger äts IPC 1100 @ 0\mod_1158840128122_681.doc @ 754 @
Note:
When selecting the mounting housing, the overall performance of the system including
built-in cards has to be observed. The housing has to be calculated correctly, that the
max. permissible ambient temperature is not exceeded.
10
Industrial PCs IPC1300
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Advertisement
Table of Contents
