Table of Contents
Advertisement
4 A
-
DD
ON CARD INSTALLATION
4.1 P
-
RE
INSTALLATION NOTES
The user can install CompactFlash or PCI add-on cards such as Interbus cards in the
device. The card slot is accessed by taking off the back cover. The crosshead screws on
the back of the control system should be removed for this purpose.
Caution:
The components in the device are highly sensitive products, which can be destroyed or
impaired by improper handling. The same applies to the PC add-on cards to be installed.
Therefore the appropriate measures have to be implemented in all cases to avoid
electrostatic shock to the components upon contact.
Pos : 17 /D atentec hni k/Stec kkar tenei nbau/Hi nweis zur Konfiguration der Stec kkarten/Hinweis e z ur Konfiguration der Stec kkarte @ 0\mod_1158844984298_681.doc @ 779 @
4.2 N
OTES ON CONFIGURING THE ADD
The Ethernet and IDE controllers on the adsX board are connected via an internal PCI bus.
Therefore the addresses and IRQs are automatically assigned by the BIOS.
The following should be considered when installing or reconfiguring ISA cards:
•
•
•
Pos : 18 /D atentec hni k/Stec kkar tenei nbau/M ontag e der Z us atz karten/Montage von Z us atz karten @ 0\mod_1158845159907_681.doc @ 781 @
14
Install and switch on device without ISA cards and then note down the assigned
IRQs and addresses.
Install additional ISA cards in such a way that the IRQs assigned to PCI controllers
are not used again.
Reserve IRQs for ISA cards in the BIOS.
-
(P
P)
ON CARD
N
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Industrial PCs IPC1300
Advertisement
Table of Contents
