Industrial PCs IPC1300
4.3 I
NSTALLING ADD
•
•
Caution:
The cover may be connected to mechanical parts in the device by a grounding wire! Do
not remove the cover with force...
•
•
•
•
Pos : 19 /D atentec hni k/Inbetri ebnahme/Systemmer kmale/Inbetri ebnahme für IPC 1100 @ 0\mod_1158845850031_681.doc @ 785 @
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
-
ON CARDS
Switch off the device and all units connected to the PC and disconnect them from
the power supply.
Unscrew the cover screws using a matching screwdriver and carefully remove the
cover.
Reduce electrostatic charge by implementing the appropriate measures (see
above), remove the add-on card from the packaging, place it in the slot and bolt it
to the card mount.
Each ISA card should be fastened in the matching slot with a clamp to prevent the
card from falling out.
Reconnect the grounding conductor if it has been removed and replace the cover
while paying attention to the side clips as the case may be.
Tighten all of the screws on the cover again.
15