Rimscan™ Wheel Profile Scanner - Hunter GSP9200 Series Operation Instructions Manual

4.10 RimScan™ Wheel Profile Scanner
46 x 4. Balancing Features and Options
NOTE: This may need to be done before the wheel is mounted on
the GSP9200.
Add the measurement from the left weight plane to the desired right weight plane to
the distance to the inner rim lip and enter this new dimension manually.
Enter the weight plane distance (mm) and diameter (in) manually.
Close safety hood.
Press the green "START" button if "Hood Autostart" is disabled.
After wheel comes to a complete stop, raise safety hood.
Place left plane weight (if in DYNAMIC mode) per the balance procedure being
performed. Refer to "Balancing Procedures," page 9.
Press the green "START" button with the safety hood in the RAISED position and the
GSP9200 will servo to the location for the right adhesive weight plane (dynamic) or
the static adhesive weight plane (static), aligned with the first spoke.
With the servo enabled, attach the adhesive weight behind the first spoke using the
weight amount shown on the LCD.
Press the green "START" button with the safety hood in the RAISED position and the
GSP9200 will servo to the location for the second spoke.
Attach the appropriate weight as displayed on the console.
All weight plane displays should show "OK," after checkspin.
SPLIT SPOKE® balancing procedure is complete.
RimScan™ wheel profile scanner analyzes and reproduces a cut-away view of the
rim profile. This is highly advantageous for difficult applications and for accurately
placing each individual wheel weight. RimScan combined with SmartWeight
single corrective weight placement simpler and more frequent, further reducing or
eliminating the static residual.
RimScan is available only if SmartWeight
adhesive weights or mixed weight balancing methods.
®
is enabled. RimScan is designed for
GSP9200 Series Wheel Balancer Operation Instructions
®
makes