Balancing Features And Options; Blinding And Rounding; Quick-Thread ® Wheel Clamping - Hunter GSP9200 Series Operation Instructions Manual

Wheel balancer computerized lcd balancer

Hide thumbs Also See for GSP9200 Series:

Table of Contents

4. Balancing Features and Options

4.2 Quick-Thread

GSP9200 Series Wheel Balancer Operation Instructions

In non-SmartWeight

mode the balancer can display either an "actual" or "blinded

and rounded" amount of imbalance.

"Blind" is a tolerance or amount of imbalance required before an imbalance amount is

displayed. "Round" allows the balancer to display weight imbalance to a desired

increment. The blind and round values can be changed in the "Setup" procedure.

Refer to "Service Mode Setup and Features," page 56.

While in the "Balance" primary screen, blind and rounding may be disabled by

rotating the control knob to highlight

selected mode will be displayed when "Blind and Rounding" are disabled as shown

below.

Wheel Clamping

Quick-Thread

is an "intelligent" DC drive motor control feature that allows motor

assisted threading for fast installation and removal of the GSP9200 wing nut. Quick-

Thread

can be enabled or disabled from the "Setup" screen.

WARNING: Keep clear of clamping components during Quick-

Thread

Lift the wheel assembly onto the shaft as normal without threading on the wing nut.

With the left hand, hold the rim over the cone to remove the weight of the rim from

the spindle and to allow maximum Quick-Thread

Place the wing nut on the spindle and rotate one full turn onto the spindle threads.

. The actual amounts of imbalance for the

shaft rotation.

wing nut travel.

4. Balancing Features and Options x 39

Table of Contents

Show Quick Links

Table of Contents