Re-Entering Similar Wheel After Split Spoke Is Enabled - Hunter GSP9200 Series Operation Instructions Manual

After wheel comes to a complete stop, raise safety hood.
Place left plane weight (if in DYNAMIC mode) per the balance procedure being
performed. Refer to "Balancing Procedures," page 9.
Press the green "START" button with the safety hood in the RAISED position and the
GSP9200 will servo to the location for the right adhesive weight plane (dynamic) or
the static adhesive weight plane (static), aligned with the first spoke.
With the servo enabled, attach the adhesive weight behind the first spoke using the
weight amount shown on the LCD. Refer to "Servo-Aided Adhesive Weight
Placement," page 33.
Press the green "START" button with the safety hood in the RAISED position and the
GSP9200 will servo to the location for the second spoke.
Attach the appropriate weight as displayed on the console.
All weight plane displays should show "OK," after checkspin.
SPLIT SPOKE® balancing procedure is complete.
®
Re-entering Similar Wheel after Split Spoke is Enabled
®
Once Split Spoke mode is enabled, use the "Set New Spoke Location" key to input
the spoke orientation of the other three rims from a set to avoid re-measuring the
weight plane dimensions each time.
44 x 4. Balancing Features and Options
GSP9200 Series Wheel Balancer Operation Instructions