Manual Adhesive Weight Placement - Hunter GSP9200 Series Operation Instructions Manual

Manual Adhesive Weight Placement

34 x 3. Balancing Procedures
Maintaining that distance, rotate the Dataset
then apply the adhesive weights to the rim.
NOTE: If the servo is off (but is enabled in setup), pressing the
"START" button with the hood in the RAISED position will
restart the servo for adhesive weight application.
NOTE: If the servo-aided weight placement is enabled, press the
"STOP" button with the hood in the RAISED position to
disable.
To manually place adhesive weights on the rim after spinning, the inner Dataset
should be used to verify the previously inputted distance.
Rotate the wheel until the location arrow of the desired weight plane is green.
®
Lift the inner Dataset arm from home position. The "real-time" number displayed
between the two numbers that represent previously inputted data displays the current
reading of the inner Dataset
position on the rim until the real-time number matches the previously inputted data.
NOTE: Lifting the inner Dataset
dimension input. Do NOT step on the foot pedal or new
dimensions will be entered.
The BDC laser locator automatically displays a vivid line at bottom dead center after
a wheel has been spun. The laser turns off when the wheel is spun again.
The weight should be placed at BDC at that distance.
®
arm toward the inner rim surface, and
®
arm. The arm should be placed in the downward
®
arm will trigger the balancer for
GSP9200 Series Wheel Balancer Operation Instructions
®
arm