Mariner 30 JET 40 (4 CYL) Service Manual page 67

2. If removed, reinstall parts on armature shaft. Use
a new locknut and tighten securely on end of
shaft.
3. Lubricate helix threads on armature shaft with a
drop of SAE 10W oil.
4. Lubricate bushing in drive end plate with a drop
of SAE 10W oil.
5. Position armature into start frame so that com-
mutator end of armature is at end of starter frame
where permanent magnets are recessed 1"
(25.4mm).
Brush Retaining Tool Layout (Full Size)
Side View (Full Size)
90-814676R1 DECEMBER 1996
6. Lubricate bushing (located in commutator end
cap) with one drop of SAE 10W oil. DO NOT over-
lubricate.
7. To prevent damage to brushes and springs when
installing commutator end cap, it is recom-
mended that a brush retaining tool be made.
Brush Retainer Tool Dimensions
ELECTRICAL AND IGNITION - 2B-15