Mariner 30 JET 40 (4 CYL) Service Manual page 267

6. Apply Special Lubricant 101 (92-13872A1) to
surface of upper pivot pin, pivot pin bore and trim
ram bore.
b
a - Pivot Pin
b - Pivot Pin Bore
c - Trim Ram Bore
7. Using a suitable mallet, drive upper pivot pin into
swivel bracket and through trim ram until pivot pin
is flushed with swivel bracket.
a
a - Pivot Pin
b - Swivel Bracket
c - Trim Ram
5C-38 - MID-SECTION
a
c
51148
b
c
51148
8. Drive upper dowel pin (a) into its hole until seated.
a
9. Recheck fluid level.
10. Power trim may now be operated to lower out-
board to desired position. Trim system is self
bleeding.
11. Re-connect spark plug leads to spark plugs.
12. Re-install top cowl.
13. Connect battery leads to battery terminals.
90-814676R1 DECEMBER 1996
51147