3. Place barrel receptacle (c) onto throttle barrel (d).
Route throttle cable (e) around port side of out-
board and position throttle cable through center
opening in rubber grommet (b).
e
4. Position barrel receptacle (a) into receptacle
guide (b).
a
b
90-814676R1 DECEMBER 1996
c
d
b
54832
54833
5. Place end of throttle cable (c) on peg of throttle
lever (d).
c
6. Secure throttle cable (c) with latch (e).
c
7. Apply a drop of Loctite 271 onto exposed threads
of throttle cable barrel set screw. (DO NOT tight-
en set screw at this time.)
CAUTION
DO NOT exceed 1/4-turn on set screw after it has
bottomed-out.
OUTBOARD MOTOR INSTALLATION/ATTACHMENTS - 7B-7
d
54834
e
54835