soundsation GO-SOUND AMW series User Manual page 10

ENGLISH
page 20. Before replacing the fuse, make sure the unit turned off and disconnected
from the AC outlet.
NOTE: If you happen to lose the AC line-cord, always use a three-pin plug
with a ground pin.
2) POWER Switch
Switch left to turn the speaker on, and switch right to turn it off. Make sure MASTER
LEVEL control is down before you turn it on.
3) ANTENNA A AND B
They receive the RF signals from the two transmitters. To increase the capacity of
reception, extend the two telescopic antennas as much as possible.
4) 12v power input and Fuse
As already anticipated in paragraph "3.2. 12Vcc Power Input" on page 7, GO-
SOUND AMW Series speakers can be powered by a 12VDC power source (such as
the battery of an automobile). This terminal is used to connect the unit to the external
source. Be sure to use cables with appropriate conductor section (1.50 mm
to avoid overheating. Be even sure to observe the correct polarity: the positive pole is
red; the negative is black.
In case of fuse burn, to prevent the risk of fire and damaging the unit, please use only
a spare of the recommended fuse type as described in the "7. SPECIFICATIONS" on
page 20.
WARNING: Before replacing the fuse, make sure the unit turned off and
disconnected from the AC outlet or any 12VDC external source.
5) Dual VHF Wireless Receiver
These portable PA systems feature two handheld wireless microphones for maximum
mobility during your performances. The dual receiver has a VHF ON/OFF switch with
POWER LED, to activate the unit and indicate it is on.
TIP: When you don't use the two wireless microphones, it is always advis-
able to turn the receiver off, so as to lengthen the battery life.
The section is also composed of two level controls, one for each of the two micro-
phones, and two RF LED indicators, which light up when there is the radio signal from
the handheld transmitter. For further details on the handheld microphone, see "5. DUAL
VHF WIRELESS MICROPHONE" on page 15.
6) MIC IN1/Mic IN2
There are two 1/4" (6.3 mm) Jack plugs that accept unbalanced Mic-level signals.
There is no phantom power, so you should use a dynamic microphone, or use a con-
10
GO-SOUND AMW series User manual
minimum)
2