Bosch DCN Installation And User Instructions Manual page 60

DCN Wireless | Installation and User Instructions | Central Devices
table 11.4: Status LEDs
Blue (A) Red (B)
Flashing (fast) Off
Flashing (fast) Off
Flashing (fast) Off
Flashing (slow) Off
Flashing (slow) Off
Off Flashing (fast)
Off Flashing
(slow)
Off Off
Off On
On Flashing (fast)
On Off
On Off
On Off
On On
Note:
• Flashing (fast) = one second on, one second off.
• Flashing (slow) = one sec on, three seconds off.
Bosch Security Systems | 2007-11 | 9922 141 70691 en
Blue (C) Description
Off The wireless mode is set to On (refer to table 10.25), and no
wireless contribution devices are connected to the system.
Flashing (fast) No wireless contribution devices are connected, and menu
item 3B, one of the 3B submenus, or 4Kd of the
configuration menu of the central control unit is open. Use
these menu items to configure the wireless access point
(refer to figure 10. 1 2).
On The wireless mode is set to Subscription (refer to table
10.25), and no wireless contribution devices are connected
to the system.
Flashing (fast) The wireless mode is set to Sleep (refer to table 10.25), and
menu item 3B, one of the 3B submenus, or 4Kd of the
configuration menu of the central control unit is open. Use
these menu items to configure the wireless access point
(refer to figure 10. 1 2).
Off The wireless mode is set to Sleep (refer to table 10.25).
Off The system prepares a software transfer to the wireless
access point.
Off The wireless mode is set to Off (refer to table 10.25), or the
power value of the wireless access point is set to Off (refer to
table 11.3). This LED sequence is also used to indicate that
the central control unit is incompatible with the wireless
access point (if this is the case, a message is also shown on
the display of the central control unit).
Off The wireless access point is off.
Off The wireless access point lost connection with the optical
network.
Off The system sends software to the wireless access point.
Flashing (fast) One or more wireless contribution devices are connected to
the system, and menu item 3B, one of the 3B submenus, or
4Kd of the configuration menu of the central control unit is
open. Use these menu items to configure the wireless
access point (refer to figure 10. 1 2).
On The wireless mode is set to Subscription (refer to table
10.25), and one or more devices are connected to the
system.
Off The wireless mode is On (refer to table 10.25), and one or
more wireless contribution devices are connected to the
system.
On Internal error in wireless access point.
en | 60