Antenna Design - DX Engineering RF-PRO-1B Manual

Active magnetic loop antenna
Table of Contents

Advertisement

Introduction
The DX Engineering rotatable DXE-RF-PRO-1B Active Magnetic Loop Antenna is designed for
reception of signals over the range of 100 kHz to 30 MHz. The RF-PRO-1B
pole, mast or any flat surface. The included very high dynamic-range low-noise preamplifier is
designed for minimum intermodulation distortion in the presence of very high-level signals that
would normally overload most preamplifiers. This rotatable loop antenna is receive ONLY.
Features
 Same technology and quality as Pixel Technologies and InLogis loop antennas
 Unique Loop architecture provides enhanced
performance
 Magnetic loop that rejects near field electrical noise
 Up to 30 dB rejection of locally radiated noise
compared to whip antennas
 Figure eight directivity and deep nulls to further
reduce interference from local or distant signals
 Very low IMD, 27 dB Low-Noise Clifton
Laboratories Norton Preamp insures good
performance in both strong and weak signal
environments
 Useable coverage range: 100 kHz to 30 MHz
 Rejects power line noise
 Rugged construction, easily mounts to a pole or flat
vertical surface, 3/4 inch dia. aluminum loop,
supplied with preamplifier, power inserter and DC
power supply
 No manual tuning necessary
 No Home Owners Association problems; low
profile, easy to camouflage and works at a few feet
above ground level
 Modular design for easy installation and maintenance
 Internal transmit / receive relay disconnects the antenna / preamplifier from receiver when
transmitting

Antenna Design

®
The RF-PRO-1B
Loop Antenna consists of a rigid 3/4 inch diameter light-weight aluminum loop
and a balanced broadband preamplifier that is housed in a separate enclosure mounted close to the
antenna on its mast bracket. A 20 volt DC regulated power inserter unit is provided. The antenna
and preamplifier has been designed to permit the use of 75 ohm cable (RG-6 is recommended and is
available from DX Engineering). For best results the antenna should be positioned a minimum of 15
feet away from any buildings or other sources of interference. The loop antenna may be rotated to
take advantage of the directional properties of this type of antenna.
2
®
can be mounted to a

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RF-PRO-1B and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents