Security - DFI SU551 User Manual

Security

This section configures the trusted platform module (TPM) function.
InsydeH20 Setup Utility
Main Advanced Security Boot
Current TPM Device <TPM 2.0>
TPM State Not Installed
TPM Availability <Available>
TPM Operation <No Operation>
Clear TPM [ ]
Supervisor Password Not Installed
Set Supervisor Password
TPM Availability
Available
Hidden
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
TPM Availability
Show or hide the TPM availability and its configurations.
TPM Operation
Enable or disable the TPM function. It displays the following options:
No Operation: No changes to current state.
Disable: Disable and deactivate TPM.
Enable: Enable and activate TPM.
Clear TPM
Remove all TPM ownership contents.
Chapter 3 BIOS Setup
Rev. 5.0
Exit
When Hidden, don't ex-
poses TPM to 0
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 3
Set Supervisor Password
Set the administrative password. The length of the password must be greater than one
character.
Main Advanced
Current TPM Device
TPM State
TPM Availability
TPM Operation
Clear TPM
Supervisor Password
Set Supervisor Password
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
32
InsydeH20 Setup Utility
Security Boot Exit
Install or Change the pass-
<TPM 1.2>
word and the length of
Enabled and Activated, Owned
password must be greater
<Available>
than one character.
<No Operation>
[X]
Not installed
Set Supervisor Password
Enter New Password:
Enter New Password Again:
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Rev. 5.0
www.dfi.com