Important Product Information; Information To The User; Specifications - Shure ANI4OUT-XLR Manual

Microflex Advance ANI4OUT Microflex Advance ANI4OUT
• A unicast flow is a point-to-point connection between two devices, supporting up to four channels per flow.
• A multicast flow is a one-to-many transmission, which supports sending up to four channels to multiple receiving devices across the network.
Shure Device Applications
Each Shure device can connect with up to two Dante devices.
The Shure MXA310 and ANI4IN support multicast transmission. This means that flows can transmit to multiple devices -- as many as the network can support.
If using unicast flows, each Shure device can connect with up to two Dante receiver devices.
The Shure ANI4OUT connects with up to two Dante transmitter devices.

Important Product Information

The equipment is intended to be used in professional audio applications.
Note: This device is not intended to be connected directly to a public internet
network.
EMC conformance to Environment E2: Commercial and Light Industrial.
Testing is based on the use of supplied and recommended cable types. The
use of other than shielded (screened) cable types may degrade EMC perfor-
mance.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate this equipment.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
Authorized under the verification provision of FCC Part 15B.
Please follow your regional recycling scheme for batteries, packaging, and
electronic waste.

Information to the user

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or

Specifications

Input
(1) RJ45
Outputs
ANI4OUT-XLR
ANI4OUT-BLOCK
Configuration
Impedance Balanced
Polarity
Non-inverting, any input to any output
Power Requirements
Power over Ethernet (PoE), Class 0
18/21
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: info@shure.de
This product meets the Essential Requirements of all relevant European di-
rectives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from Shure Incorporated
or any of its European representatives. For contact information please visit
www.shure.com
(4) XLR connector
(4) 3-pin block connector
Shure Incorporated
2016/08/24