Using The Software; Software Installation And Device Discovery; Accessing The Web Application; Accessing The Web Application Without The Discovery App - Shure ANI4OUT-XLR Manual

Microflex Advance ANI4OUT Microflex Advance ANI4OUT
Note: When summing is enabled, a limiter is activated to prevent signal overloading. The limiter never applies to the direct outputs, and only affects the summed
signal.
To enable, select one of the summing options in the toolbar at the top of the mixer in the channels tab.

Using the Software

Software Installation and Device Discovery

The Shure Web Device Discovery application is used to access the web application for a Shure device. The web application opens in a web browser to provide
comprehensive device management. Any computer networked to the device can access the GUI with this application.
Compatible Browsers:
• Chrome
• Safari
• Firefox
• Internet Explorer
1. Install the Shure device discovery application, available at www.shure.com
2. Double-click the component to open the interface.

Accessing the Web Application

The Shure Web Server Discovery application finds all Shure devices on the network that feature a web-based GUI. Follow these steps to install the software
and access the web application:
① Install the Shure Discovery application
Download and install the Shure Discovery application from www.shure.com. This automatically installs the required Bonjour device discovery tool on the com-
puter.
② Connect the network
Ensure the computer and the hardware are on the same network.
③ Launch the Discovery application
The app displays all Shure devices that feature a GUI.
④ Identify the hardware
Double-click on a device to open its GUI in a web browser.
⑤ Bookmark the device's web application (recommended)
Bookmark the device's DNS name to access the GUI without the Shure Discovery app.

Accessing the Web Application without the Discovery App

If the Discovery application is not installed, the web application can be accessed by typing the DNS name into an internet browser. The DNS name is derived
from model of the unit, in combination with the last three bytes (six digits) of the MAC address, and ending in .local.
Format Example: If the MAC address of a unit is 00:0E:DD:AA:BB:CC, then the link is written as follows:
10/21
1
1
2
2
3
3 + 4
4
1
2
1 + 2 + 3 + 4
3
4
1
1 + 2
2
3
3 + 4
4
1
1 +2
2
3
3
4
4
Shure Incorporated
2016/08/24