Table of Contents
Advertisement
Problem
Incomplete Fusing
Toner appears to be pulled off print, or is
easy to rub off.
Image Offset
Toner appears to have been pulled off the page and
placed about 82.25 mm down the page from where it
should be.
Page 2 of 3
Solution
1.
From the printer's front panel
Improve Print
Quality?, then select
2.
Ensure the paper you are using is the correct type for the
printer and is properly loaded.
3.
Ensure the paper loaded in the tray matches the paper type
selected on the printer's front panel and in the printer driver.
4.
If the problem persists, select the appropriate
Menu
for the tray you are using and set the paper type to
the next heaviest type of paper. Refer to the
Page
for media types and weight.
Note:
To access the
and close the selected paper tray or re-insert
the paper loaded in the MPT. The front panel
will then prompt you to select the paper type.
1.
From the printer's front panel
Print
Quality?, then select
press OK.
2.
Ensure the paper you are using is the correct type for the
printer and is correctly loaded in tray.
3.
Ensure the paper loaded in the tray matches the paper type
selected on the printer's front panel and in the printer driver.
4.
If the problem persists, select the appropriate
Menu
for the tray you are using and set the paper type to
the next lightest type of paper. Refer to the
Page
for media types and weight.
Note:
To access the
and close the selected paper tray or re-insert
the paper loaded in the MPT. The front panel
will then prompt you to select the paper type.
Support Menu
select
Print Paper Tips
Tray Setup
Paper Tips
Paper Type
Menu, open
Support Menu
select
Print Paper Tips Page
and
Tray Setup
Paper Tips
Paper Type
Menu, open
Page.
Improve
Advertisement
Table of Contents
