Vega VEGAPULS 66 Operating Instructions Manual page 32

Setup with the indicating and adjustment module PLICSCOM
Medium selection
Vessel form
32
1 Prepare the % value for editing with [OK] and set the
cursor to the requested position with [->]. Set the
requested percentage value with [+] and save with [OK].
The cursor jumps now to the distance value.
2 Enter the appropriate distance value in m (corresponding
to the percentage value) for the full vessel. Keep in mind
that the max. level must lie below the dead band.
3 Save the settings with [OK] and move to "Medium
selection" with [->].
Each product has different reflective properties.
According to the conductivity and the dielectric value of liquids,
the reflection properties can differ considerably. Therefore
additional options such as "Solvent", "Chem. mixture" and
"Water based" are offered below the menu item Liquid.
Through this additional selection, the sensor is adapted
perfectly to the product and measurement reliability, partic-
ularly in products with bad reflective properties, is considerably
increased.
Medium
Liquid
Water based
Acids/Bases
Enter the requested parameter via the appropriate keys, save
your settings and jump to the next menu item with the [->] key.
Neben dem Medium kann auch die Behälterform die Messung
beeinflussen. Um den Sensor an diese Messbedingungen
anzupassen, bietet Ihnen dieser Menüpunkt je nach Auswahl
von Flüssigkeit oder Schüttgut verschiedene Auswahlmö-
glichkeiten. Bei "Flüssigkeit", "Lagertank", "Standrohr", "Offe-
ner Behälter" oder "Rührwerksbehälter", bei "Schüttgut" sind
dies "Silo" oder "Bunker".
Vessel form
Storage tank
Enter the requested parameter via the appropriate keys, save
your settings and jump to the next menu item with the [->] key.
VEGAPULS 66 standpipe version - Profibus PA