Configuring The Radio Of An Ap; Configuring A Radio Interface - H3C WA Series Configuration Manual

Configuring the Radio of an AP

Follow these steps to configure the radio of an AP:
To do...
Enter system view
Enter radio interface view
Specify a radio type for the
radio
Map a service template to
the current radio
Specify a channel number
for the radio
Specify the maximum radio
power
Specify the type of
preamble

Configuring a Radio Interface

A set of radio parameters can be configured for a radio interface. If a radio interface is mapped to a radio
(for example, 802.11b/g or 802.11a), all parameters configured for the radio interface apply to the radio.
Follow these steps to configure a radio interface:
To do...
Enter system view
Enter radio interface view
Set the interval for sending beacon
frames
Set the number of beacon intervals
between DTIM frames
Specify the fragmentation
threshold
Specify the Request to Send (RTS)
threshold
Use the command...
system-view
interface wlan-radio
interface-number
radio-type { dot11b | dot11g |
dot11a }
service-template
service-template-number
interface wlan-bss
interface-number
channel { channel-number |
auto }
max-power max-power
preamble { long | short }
Use the command...
system-view
interface wlan-radio
interface-number
beacon-interval interval
dtim counter
fragment-threshold size
rts-threshold size
10-9
Remarks
—
—
Required
Required
Optional
By default, auto mode is enabled.
The working channel of a radio varies with
country codes and radio types. The channel
list depends on your device model.
Optional
By default, the maximum radio power varies
with country codes, channels, AP models,
radio types and antenna types. If 802.11n is
adopted, the maximum radio power also
depends on the bandwidth mode.
Optional
By default, the short preamble is supported.
Remarks
—
Required
Optional
100 time units (TUs) by default.
Optional
The default is 1.
Optional
By default, the fragmentation
threshold is 2346 bytes.
Optional
By default, the RTS threshold is
2346 bytes.