Adjustment; Adjustment Required When The Set Is Repaired Or Replaced - Pioneer PRO-810HD Service Manual

1

6. ADJUSTMENT

A
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.
6.1

ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED

When any of the following assemblies is replaced
B
POWER SUPPLY Unit
DIGITAL VIDEO Assy
50 X DRIVE Assy
50 Y DRIVE Assy
C
AV I/O Assy
RGB Assy
VIDEO SLOT Assy
Other assemblies
Service Panel
D
When any part in the following assemblies is replaced
POWER SUPPLY Unit
DIGITAL VIDEO Assy
50 X DRIVE Assy
E
50 Y DRIVE Assy
AV I/O Assy
RGB Assy
VIDEO SLOT Assy
F
Other assemblies
92
1
2
No adjustment required
Copy of backup data requires.
• When adjust with the service factory mode, refer to
"10.DIGITAL EEPROM" of "6.2 SERVICE FACTORY MODE."
• When adjust with the command, refert to "7.1.6 BACKUP
THE ADJUSTMENT VALUES FOR THE MAIN UNIT."
No adjustment required
No adjustment required
No adjustment required
No adjustment required
No adjustment required
No adjustment required
Refer to "6.4 METHOD FOR REPLACING THE SERVICE
PANEL ASSY."
The assembly must be replaced as a unit, and no part
replacement is allowed.
No adjustment required
No adjustment required
No adjustment required
Replacement and repair of IC6803, IC6810, IC7610 and
IC8705 are impossible.
Replacement and repair of IC6001, IC6401, IC6403,
IC6601, IC6602 and IC7205 are impossible.
Replacement and repair of IC6107, IC6255, IC6257
and IC7902 are impossible.
No adjustment required
PRO-1010HD
2
3
3
4
4