Pioneer PRO-810HD Service Manual page 151

5
4
X CONNECTOR A Assy, B Assy, 43 SCAN A Assy and B Assy
X CONNECTOR A and B Assy
1
Remove the enclosure sheet 1.
Note:
Enclosure sheet 1 is attached to comply with the safety
standards. Make sure that it will not be shifted or peeled off.
If it is peeled off, securely reattach it in its original place.
2
Remove the jumper wire by removing the flat clamp.
3
Remove the one nylon rivet.
4
Remove the one screw.
Note: Be sure to remove this screw. If you don't, the connector
on the LED Assy may be damaged.
5
Remove the LED Assy.
6
Remove the front chassis VR (43M) by removing the five
screws.
7
Remove the six screws.
8
Remove the X CONNECTOR A and B Assy.
Note when reassembling the front chassis VR (43M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.
43 SCAN A and B Assy
1
Remove the one nylon rivet.
2
Remove the jumper wire by removing the flat clamp.
3
Remove the one screw.
4
Remove the front chassis VL (43M) by removing the five
screws.
5
Remove the four screws.
6
Disconnect the two pin connectors.
7
Remove the two spacers.
8
Remove the four spacers.
9
Remove the 43 SCAN A and B Assy.
Note when reassembling the front chassis VL (43M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.
5
6
6
6
Flat
clamp
Enclosure
sheet 1
X CONNECTOR B Assy
4
4
Front chassis VL (43M)
8
43 SCAN B Assy
PRO-1010HD
6
7
6
43 X DRIVE Assy
Front chassis VR (43M)
3
2
1
5
LED Assy
43 X DRIVE Assy
7
×2
8
X CONNECTOR A Assy
4 43 Y DRIVE Assy
Flat clamp
3
43 Y DRIVE Assy
5
5
×2
6
7
7
8 8
9
43 SCAN A Assy
7
8
A
6
6
4
B
7
×4
C
8
4
D
4
2
1
E
×2
6
8
9
F
151
8