Pioneer PRO-810HD Service Manual page 147

5
4
X CONNECTOR A Assy, B Assy, 50 SCAN A Assy and B Assy
X CONNECTOR A and B Assy
1
Remove the enclosure sheet 1.
Note:
Enclosure sheet 1 is attached to comply with the safety
standards. Make sure that it will not be shifted or peeled off.
If it is peeled off, securely reattach it in its original place.
2
Remove the jumper wire by removing the flat clamp.
3
Remove the one nyron rivet.
4
Remove the one screw.
Note: Be sure to remove this screw. If you don't, the connector
on the LED Assy may be damaged.
5
Remove the LED Assy.
6
Remove the front chassis VR (50M) by removing the five
screws.
7
Remove the eight screws.
8
Remove the X CONNECTOR A and B Assy.
Note when reassembling the front chassis VR (50M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.
50 SCAN A and B Assy
1
Remove the one nylon rivet.
2
Remove the jumper wire by removing the flat clamp.
3
Remove the one screw.
4
Remove the front chassis VL (50M) by removing the five
screws.
5
Remove the SCAN heatsink by removing the two screws.
6
Remove the ten screws.
7
Disconnect the two pin connectors.
8
Remove the two spacers.
9
Remove the 50 SCAN A and B Assy.
Note when reassembling the front chassis VL (50M)
Remove or loosen the screws that secure the panel holder in
order not to damage the front protect panel Assy.
5
6
6
6
Flat
clamp
Enclosure
sheet 1
X CONNECTOR B Assy
5
SCAN heatsink
4
4
Front chassis VL (50M)
6
9
50 SCAN B Assy
PRO-1010HD
6
7
50 X DRIVE Assy
6
Front chassis VR (50M)
2 3
1
5
LED Assy
50 X DRIVE Assy
7
×4
8
X CONNECTOR A Assy
5
50 Y DRIVE Assy
4
Flat clamp
3
50 Y DRIVE Assy
6
6
×3
6 6
7
8
8
50 SCAN A Assy
7
8
A
6
6
4
B
7
×4
C
8
D
4
4
2
1
E
×3
6
7
9
F
147
8