SATO WS408TT Technical Manual page 91

4 SATO WS4 Printer Utility
8. Click Send to run the command on your printer.
Note If you send a command file and your printer doesn't respond, it is possible
that the emulation language is not set correctly. Click Sync to get the current
setting of Printer Emulation.
Tool
Tool is used to send specific commands to your printer. It has the Single Command
tab, which provides three commands.
Reboot Printer
■
Reset to Default Setting
■
Test Print
■
Change Emulation
■
Media Calibration
■
Ribbon Calibration
■
will be more accurate.
RESET
•
Restart your printer.
Reload factory settings.
Run a self-test to print a configuration label.
Change the emulation language for your printer.
Change the media sensor for your printer.
It calibrates the ribbon so that your print start position
Turn off Ribbon Calibration.
88
Work with SATO WS4 Printer Utility