Preparing For Installation; Site Preparation - Cisco 2000 4xGBE Quick Start Manual

Revised: September 17, 2012, OL-26789-01
This document supports all 3.8.x releases.
Note
1

Preparing for Installation

This section contains warnings, tools and part information, and site preparation details.
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents.
Warning Only trained and qualified personnel should install, replace, or service this equipment.
Warning Read the installation instructions before you connect the system to its power source.
Warning This unit is intended for installation in restricted access areas. A restricted access area is where access can only
be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is
controlled by the authority responsible for the location.
Warning Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock, keep hands
and fingers out of the power supply bays and backplane areas.
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning Before you begin the installation of the SCE 2000 platform, read the
for the Cisco Service Control Engines (SCE)

Site Preparation

• Print out and have accessible the
Installation and Configuration
• Verify that the power service at the site is suitable for the SCE 2000 chassis.
• Verify that there is at least a two inch (5 cm) clearance on both sides of the SCE 2000 and five inches (12.7 cm) at the rear
for adequate airflow for the inlet and exhaust vents.
2
document.
"Cisco SCE 2000 GBE Installation
Guide, to record information about this installation.
Regulatory Compliance and Safety Information
Checklist", found in the Cisco SCE 2000 GBE