Installing The Crossrail Supports (Four-Post Rack Only); Assembling The Crossrail Supports; Attaching The Crossrail Supports To The Rack - Cisco 2000 4xGBE Quick Start Manual

Installing the Crossrail Supports (Four-post rack only)

This section provides information for assembling the crossrail supports and attaching them to the rack.
When mounting in a rack with four posts (front and back) the two crossrail supports are mounted one on each side of the rack.
The SCE 2000 then slides into these crossrails, which support the weight of the unit.

Assembling the Crossrail Supports

Assemble the two crossrail supports. Use three screws for each crossrail assembly.
Step 1
Figure 6 Assembling the Slider Brackets
1
Make sure that they are oriented so that both crossrails will support the SCE 2000 when they are attached to the rack.
Step 2

Attaching the Crossrail Supports to the Rack

Align the crossrail supports with the side of the rack, parallel to the floor.
Step 1
Figure 7 Attaching the Crossrails to the Rack
Insert and tighten two screws to the front posts or mounting strips of the rack
Step 2
Insert and tighten two screws to the back posts of the rack.
Step 3
Step 4 Repeat steps 2 and 3 on the other side of the rack, keeping the brackets flush against the posts and parallel to the
supporting bracket on first side of the rack.
2 3
1 2 3
7