Inserting And Removing The Drive Cage; Removing The Drive Cage - Fujitsu ESPRIMO Q55x Operating Manual

Inserting and removing the drive cage

You first need to remove the drive cage to be able to install and remove drives
and components on the top side of the casing.

Removing the drive cage

• The top casing cover has been removed (see
Drive cage
When removing the drive cage, ensure that you do not damage any of the leads attached
to the main board that are attached to components in the drive cage. For this reason,
always remove the drive cage very carefully and do not pull hard on the attached leads.
a
a
1
2
► Grip the two openings (b) and carefully lift the drive cage at an angle
(1). Be careful of attached leads.
► Remove the guides (a) on the drive cage from the corresponding openings on the casing (2).
You can find information on pin allocation on the mainboard in Section
drive bays and drives in your device", Page 62
► Carefully lay the drive cage to the side (3).
Fujitsu
b b
1
2
"Removing the top casing cover", Page
and in your mainboard manual.
System expansions
65).
3
"Overview of the
67