Advertisement
H-LCD2000Service Manual
To exchange any two program's channel numbers directly in TV mode.
For instance, if CCTV is stored at channel 18 after Auto Searching, you can exchange
CCTV to channel 1 directly.
Channel Skip
After Auto Searching, there may be some repeated programs or interior signal received.
Skipping the undesired program position can dramatically quicken program selection.
1. Select Channel Skip to enter the Channel Skip mode.
】/【
2. Press the【
3. Press the【CH+】/【CH-】you will find the position number skipped.
4. Input the channel number directly to resume the position number that has been
skipped.
II. In PC, DVI Modes
General operation
Signal Sources Switch
1. Press 【TV/AV】 to switch between PC, S-Vedio, YPbPr, TV, and AV signal sources. The
operation is same to the TV mode.
2. Press the【PC】to switch between TV and PC modes directly.
3. Press any of the ten Arabic numerals 0 to 9 to watch these programs.
Volume Control
The operation is same to the TV mode.
Mute
The operation is same to the TV mode.
Information Display
Press the【DISPLAY】to check the signal source. Press it again to exit.
In the illustration above, PC is the signal source, 800 X 600 is the resolution, and 60Hz is
the refresh rate.
57
】to on/off the Channel Skip mode of the current channel.
15
Page 15 of
Advertisement
