PEUGEOT 4008 Online Manual page 69

Triggering of the alarm
this is indicated by sounding of the siren
and flashing of the direction indicators for
thirty seconds.
A message then appears in the instrument
panel screen while the siren is operating.
When the ignition is next switched on
(ON mode if your vehicle has the "Keyless
entry and Starting" system), an audible signal
sounds four times to inform you that the alarm
was triggered during your absence.
Complete deactivation of
the alarm
You can completely deactivate the alarm
system. to do this, proceed as follows:
F Switch off the ignition (OFF mode if
your vehicle has the "Keyless entry and
Starting" system).
F Remove the key from the ignition switch,
if your vehicle does not have the "Keyless
entry and Starting" system.
F Open the driver's door.
F Place the lighting control stalk in
the "OFF" position.
F Pull the wiper control stalk towards you and
hold.
After about ten seconds there is an audible
signal.
F When the audible signal stops, continue to
hold the wiper stalk pulled towards you and
press the remote control locking button.
F the state of the system is then signalled to
you by the number of beeps:
One beep: the alarm system is completely
deactivated.
two beeps: the alarm system is activated.
each new press of the remote control
locking button changes the state of the
system.
Access
2
67