Advertisement
Table of Contents
- 1 Table of Contents
- 2 Important Safety Information
- 3 Important Safety Information
- 4 Component Identification
- 5 Assembly Instructions
- 6 Operating Instructions
- 7 Applying Detergent and General Operating Techniques
- 8 Shut down and Clean-Up
- 9 Storage
- 10 Troubleshooting
- 11 Preventative Maintenance
- 12 Hose & Spray Gun Assembly
- 13 Oil Change Record
- 14 Warranty
- Download this manual
Advertisement
Table of Contents
Related Manuals for Hotsy DB-2323
Summary of Contents for Hotsy DB-2323
- Page 1 OPERATOR’S MANUAL ■ DB-2323 ■ DB-2324 ■ DB-2527 ■ DB-3030 ■ DB-3835 ■ DB-3540 For technical assistance or the dealer nearest you consult our web page at www.hotsy.com 8.914-449.0...
-
Page 3: Table Of Contents
The model and serial numbers will be found on a decal attached to the pressure washer.You should record both serial number and date of purchase and keep in a safe place for future reference. Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 4: Important Safety Information
WARNING: Risk of injury. Disconnect battery ground terminal before servicing. 8. Transport/repair with fuel tank EMPTY or with fuel shut-off valve OFF. Hotsy DB • 8.914-449.0 • Rev. 11/15... - Page 5 22. Never run pump dry or leave spray gun closed children. Do not allow chil- longer than 1-2 minutes. dren to operate the pressure washer. This ma- chine must be attended during operation. Hotsy DB • 8.914-449.0 • Rev. 11/15...
-
Page 6: Important Safety Information
25 PSI. c. Replace the valve cap to the tire valve and tighten firmly. Tire pressure should not exceed 25 PSI. Follow the maintenance instructions specified in the manual. Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 7: Component Identification
Detergent Injector — Allows you to siphon and mix water will discharge from pump protector onto detergents. floor. This system prevents internal pump dam- Wand — Must be connected to the spray gun. age. Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 8: Assembly Instructions
Hose Pump Water Inlet STEP 10: Check inlets filters, remove debris, then connect the garden hose to pump water inlet. CAUTION: Do not run the pump without water or pump damage will result. Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 9: Operating Instructions
When the engine is not in use, leave the fuel valve in run position). Move the choke lever to the "Closed" the "OFF" position. position. To restart a warm engine, leave the choke lever in the "Open" position. Hotsy DB • 8.914-449.0 • Rev. 11/15... - Page 10 NOTE: For a more gentle rinse, select the white 40° or green 25° nozzle. To scour the surface, select the yellow 15° or red 0° nozzle. To apply de- tergent select the black nozzle. Hotsy DB • 8.914-449.0 • Rev. 11/15...
-
Page 11: Applying Detergent And General Operating Techniques
Apply safety latch to spray gun. Remove black soap nozzle from the quick coupler. Select and install the desired high pressure nozzle. NOTE: You can also stop detergent from flowing by simply removing detergent siphon tube from bottle. Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 12: Shut Down And Clean-Up
3. Pour about one teaspoon of engine oil through NOTE: Refer to the engine manufacturer's manual for the spark plug hole, pull the starter grip several service and maintenance of the engine. Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 13: Troubleshooting
Water sprayed at machine Change oil. Direct spray away from ma- WATER chine. IN PUMP OIL High humidity in air Check and change oil twice as often. Contact local dealer. Piston packing worn. Oil seal worn. Hotsy DB • 8.914-449.0 • Rev. 11/15... - Page 14 PUMP IS NOISY Pump is sucking air Check that hoses and fittings are air tight. Turn off machine and purge pump by squeezing trigger gun until a steady flow of water emerges through nozzle. Hotsy DB • 8.914-449.0 • Rev. 11/15...
-
Page 15: Preventative Maintenance
After first 50 hours, then every 500 hours or annually Replace High Pressure Nozzle Every 6 months Replace Quick Connects/O-Rings Annually/As needed Clean Water Screen/Filter Weekly Replace HP Hose Annually (if there are any signs of wear) Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 16: Hose & Spray Gun Assembly
Hose, 3/8X25', 1W, TS, Hotsy, So x Sw (2300 PSI Models) 8.739-107.0 Hose, 3/8X50', 1W., TF, Hotsy, So X S (2400, 2700 and 3000 PSI Models) 8.739-183.0 Hose, 3/8X50', 2W, TF, Hotsy, SO X SW (3500 and 4000 PSI Models) 8.751-269.0... -
Page 17: Oil Change Record
Check pump oil and engine oil level before first use of your new pressure washer. Estimated Operating Estimated Operating Date Oil Changed Hours Since Last Date Oil Changed Hours Since Last Month/Day/Year Oil Change Month/Day/Year Oil Change Hotsy DB • 8.914-449.0 • Rev. 11/15... -
Page 18: Warranty
Hotsy does not authorize any other party, including authorized Hotsy Distributors, to make any representation or promise on behalf of Hotsy, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of Hotsy products conforms to local codes. - Page 19 If you need service on your pressure washer, contact your local Hotsy dealer or visit www.Hotsy.com. Smart phone users scan the code below to link directly to the Service Request page. Form #8.914-449.0 • Revised 11/15 • Printed in U.S.A. or Mexico by Hotsy...